Please note: You will need a Snapper USB or a Snapper Feeder in order to use the MySnapper Application.
If you have installed any software on your Mac previously then you will be familiar with the installation process that MySnapper uses. Just click on the button above and go for it. If you’re not too sure however, then you may find the instructions below helpful.
1. Select the download file for Mac by clicking the button above. It should start to download the "MySnapper.dmg" file automatically.
2. Open the "MySnapper2.pkg"
3. Click "Continue" to run the "MySnapper Installer.pkg". This will start the MySnapper Installer
4. Click "install" to proceed with the installation.
5. If prompted, enter your administrator username and password.
6. Select close to complete the installation.
Unless you chose a different destination, you will find MySnapper under Applications. To use MySnapper immediately, double click on the MySnapper icon. You may also wish to drag the MySnapper icon to your Dock, so that it’s close at hand whenever you need it.
That’s it, you’re done! We think that using the MySnapper application is pretty easy, but if you need a little extra guidance, then go to the MySnapper FAQs for more information.